Lanier 5813 - Manual (Page 150)

Adjustment and Color Memory
134
4
Color Balance Sample
Adjusting the color balance by trial and error could require many copies. The
color balance sampling function allows you to produce nine samples on two
copies. The first sample of each sheet uses the current color balance (standard).
Each sample after that changes one toner color by a fixed number of steps.
Note
❒ The sample will be copied on two A4K, 8 1 /
2
"
× 11"K sheets or two A3L, 11"
× 17"L sheets.
❒ Selecting Color Balance Sample does not reset the adjustments, allowing you
to make many samples while progressively changing the balance. The sample
might yield a color balance outside the copier's range which will be repro-
duced on the sample but not on the copy. For example, if yellow is already
adjusted to +3 and you select Sample
±4, the yellow samples will be copied at
yellow +7 and –1, but the adjustment for the final copy cannot be set to +7.
❒ The sampled area is as shown in the illustration.
1. Sampled area
A
Press the
{{{{Adjustment/Memory}}}} key.
B
Make sure the [Color Balance Adj.] key is selected.
Cattleya2-2_FM.book Page 134 Thursday, December 14, 2000 8:17 PM