Lanier 5813 User Manual

Page 58

Copying

❒ Select one of the following settings or keys:

• [Normal]: normal paper, adhesive labels
• [Thick]: thick paper, post cards, translucent paper
• [Extra Thick]: Heavier than 157g/m

, 42 lb

• [OHP]: OHP transparencies
• [Duplex Back]: Copying onto the reverse side of paper that has been already

copied onto.

⇒ P.49 “Copying onto the reverse side of paper”.

• [Custom Size]: Custom sized paper.

⇒ P.45 “Copying onto custom size paper

with the bypass tray”.

❒ When you copy onto OHP transparencies, you can select whether a blank slip

sheet is inserted between OHP transparencies.

❒ When you set several sheets at a time, fan them to get air between them before

❒ If the copy paper is curled, gently roll it to remove the curl.
❒ When you copy onto OHP transparencies, insert them with the copy side up.
❒ Do not stack copy paper above the limit mark.
❒ If the copy paper is bent, correct it before setting paper in the bypass tray. If

the bent part is not corrected, a paper misfeed might occur.

❒ When the optional sorter stapler is installed, copies made onto thick or OHP

transparencies are not delivered in the proof tray but in the first bin instead.

❒ When setting custom size paper, be sure to set the size after pressing the [Cus-

tom Size]

key.

Important

❒ Do not set normal paper in the Extra Thick mode, otherwise a paper misfeed

or other malfunction might occur.

Cattleya2-2_FM.book Page 42 Thursday, December 14, 2000 8:17 PM