Lanier 5813 User Manual

Page 230

Changing the Machine's Settings

214

Control Panel Off
Level

The machine enters Energy Saver mode automatically after your job is
finished.

Three Energy Saver levels are available:

• Level 1

The back light of the panel display goes off.
Warm-up time: 0 seconds

• Level 2

Power consumption is a 25% decrease compared to stand-by.
Warm-up time: Approximately 170 seconds

• Level 3

Power consumption is a 40% decrease compared to stand-by.
Warm-up time: Approximately 260 seconds

Note

❒ Default: Level 1

System Reset Timer
(Printer Option Re-
quired)

The machine returns to its prioritized mode automatically a certain
time after your job is finished, after the selected time. The time can be
set from 10 to 990 seconds (in 10 seconds steps), or off.

Note

❒ Default: On (60 seconds)

Function Reset Timer
(Printer Option Re-
quired)

When Interleave Print is turned on and a print job comes along while
the machine is busy printing another job, this delay specifies how long
the machine will wait before switching to the priority print job.

The time can be set from 10 to 990 seconds.

Note

❒ Default: On (60 seconds)

Tray Paper Size

Select the size of the copy paper set in the paper tray.

Note

❒ If the specified paper size differs from the size of paper actually set

in the paper tray, a paper misfeed might occur because the paper
size is not detected correctly.

Reference

For details,

⇒ P.235 “Mainframe”.

Paper Tray Priority

You can select the paper tray which will be selected as a default in the
following conditions:

• When the main power switch or operation switch is turned on.

• When System Reset or Auto Reset mode is turned on.

• When the

{Clear Modes} key is pressed.

• When the Auto Paper Select mode is not selected.

Note

❒ Default: Tray 1

Menu

Description

Cattleya2-2_FM.book Page 214 Thursday, December 14, 2000 8:17 PM