LevelOne GSW-2600TXM - Manual (Page 52)

52
You can create a new VLAN group or modify the members of an existing group by
pressing “Select” on the Add Subnet screen.
Port Group Configuration
========================
Port 1 2
VLAN 12345678901234567890123456
1 PPPPPPPPPPPPPPPPPPPPPPPP S:
Static
P:
PVID
Page : 1 Total: 1 Pages
Enter page number than press 'Apply' to see port group. |
READ/WRITE
Use or arrow keys to move, other keys to make changes.
Parameter Description
VLAN
A VLAN already configured on this switch.
Port Port entries may be marked as:
S : Adds port as a static entry.
P : Adds port as a static entry, and sets the port’s PVID to this VLAN ID.
Note:
Use the and buttons to scroll through the table. To
display a specific page, set the page number in the Page field and then select
. To modify a VLAN, highlight the entry in the table and select Enter. To
add a new VLAN, select .
Modifying an IP Interface
To modify an IP interface, first highlight the IP address in the Subnet Configuration
menu, and then select Enter. The Modify Subnet screen is nearly the same as the Add
Subnet screen described on chapter 2 “Add an IP Interface”. However, it also includes
an “Advanced” option that allows you to configure the unicast and multicast routing
protocols as described in the following sections.