LevelOne GSW-2600TXM - Manual (Page 50)

50
IP Subnet Configuration
=======================
Intf. IP Address Subnet Mask VLAN RIP OSPF DVMRP
Status
1 192.168.1.254 255.255.255.0 1 DISABLED DISABLED
DISABLED ON
Page 1 Total 1
Pages
The page number. |
READ/WRITE
Use or arrow keys to move, other keys to make changes.
Parameter Description
IP Address The IP address associated with the specified VLAN interface. By
convention, the last three digits should be set to “254” to readily
distinguish this device as a router port.
Subnet Mask A template that identifies the address bits in the host address used for
routing to specific subnets. Each bit that corresponds to a “1” is part of the
network / subnet number, and each bit that corresponds to “0” is part of
the host number.
VLAN The VLAN associated with this IP interface.
RIP Routing Information Protocol for unicast routing.
OSPF Open Shortest Path First unicast routing protocol.
DVMRP Distance-Vector Multicast Routing Protocol.
Note:
Use the and buttons to scroll through the subnet
configuration table. To display a specific page, set the page number in the Page
field and then select . To modify an IP interface, highlight the entry in the
table and select Enter. To add an IP interface, select .
Adding an IP Interface
Select on the Subnet Configuration menu to add an IP interface. When the Add
Subnet screen opens as shown below, assign a VLAN group to this interface, configure
the IP address, and then enable the required routing protocols. You can specify a VLAN
that has already been configured on this switch or select “Select” to open the Port