LevelOne GSW-2600TXM User Manual
Page 20
20
IP Configuration
================
Interface Type : Ethernet
IP Address : 192.168.1.254
Subnet Mask : 255.255.255.0
Gateway IP : 0.0.0.0
IP State : USER-CONFIG
Mgt. Access : All
VLANs
IP address of this system for Ethernet. |
READ/WRITE
Use
Parameter Description
Interface Type
Indicates IP over Ethernet.
IP Address
IP address of the switch you are managing. The system supports
SNMP over UDP / IP transport protocol. In this environment, all
systems on the Internet such as network interconnection devices
and any PC accessing the agent module (or running network
management software) must have an IP address.
Valid IP addresses consist of four numbers, 0 to 255, separated by
periods. Anything outside this format will not be accepted by the
configuration program.
Subnet Mask
Subnet mask of the switch. This mask identifies the host address
bits used for routing to specific subnets.
Default Gateway
Gateway used to pass trap messages from the system’s agent to
the management station. Note that the gateway must be defined
(when operating at Layer 2) if the management station is located in
a different IP segment.
IP State
Specifies whether IP functionality is enabled via manual
configuration, or set by Boot Protocol (BOOTP). Options include:
USER-CONFIG IP functionality is enabled based on the default
or user specified IP Configuration.
(This is the default setting.)
BOOTP Get IP
IP is enabled but will not function until a BOOTP
reply has been received. BOOTP requests will
be broadcast periodically by the switch in an
effort to learn its IP address.
(BOOTP values can include the IP address,
default gateway, and subnet mask.)
Mgt. Access
Allows management access of the switch from all VLANs or only