Lexmark 436 User Manual
Page 20
2
Unpack the card.
Note: Avoid touching the connection points along the edge of the card.
3
Holding the card by its sides, align the card with the connector on the system board.
4
Push the card firmly into place.
Notes:
•
The entire length of the connector on the card must touch and be flush against the system board.
•
Be careful not to damage the connectors.
•
If your printer model does not fax, your system board will not have the fax card attached to the system
board.
5
Close the system board door.
Additional printer setup
20