Lexmark 436 - Manual (Page 157)

Administrative support
Finding advanced networking and administrator information
This chapter covers basic administrative support tasks. For more advanced system support tasks, see the Networking
Guide on the Software and Documentation CD and the Embedded Web Server Administrator's Guide on the Lexmark
Web site at www.lexmark.com.
Restoring the factory default settings
1 From the printer control panel, press .
2 Press the arrow buttons until Settings appears, and then press .
3 Press the arrow buttons until General Settings appears, and then press .
4 Press the arrow buttons until Factory Defaults appears, and then press .
5 Press the arrow buttons until Restore Now appears, and then press .
Wait for Submitting Changes to appear momentarily, followed by Restoring Factory Defaults,
before the printer returns to Ready.
Warning—Potential Damage: Restore Now returns all printer settings to the factory default settings except
Network/Port menu settings. All downloads stored in RAM are deleted. Downloads stored in flash memory are
not affected.
Using the Embedded Web Server
If the printer is installed on a network, the Embedded Web Server is available for a range of functions including:
• Viewing a virtual display of the printer control panel
• Checking the status of the printer supplies
• Configuring printer settings
• Configuring network settings
• Viewing reports
To access the Embedded Web Server, type the printer IP address into the address field of your Web browser.
Notes:
• If you do not know the IP address of the printer, then print a network setup page and locate the IP address in
the TCP/IP section.
• For more information, see the Networking Guide on the Software and Documentation CD and the Embedded
Web Server Administrator's Guide on the Lexmark
TM Web site at www.lexmark.com.
Administrative support 157