Lexmark 436 - Manual (Page 183)

3 Remove the excess flash memory.
4 Connect the power cord to a properly grounded outlet.
5 Turn the printer back on.
• Press to clear the message and continue printing.
58 Too many trays attached
1 Turn the printer off.
2 Unplug the power cord from the wall outlet.
3 Remove the additional trays.
4 Connect the power cord to a properly grounded outlet.
5 Turn the printer back on.
84 PC Kit life warning
The photoconductor kit is near exhaustion.
Try one or more of the following:
• Replace the photoconductor kit.
• Press to clear the message and continue printing.
84 Replace PC Kit
The photoconductor kit is exhausted. Install a new photoconductor kit.
88.yy Cartridge is low
Replace the toner cartridge, and then press to clear the message and continue printing.
200.yy Paper jam
The message indicates either where the paper is jammed or the number of pages jammed.
1 To access the jam, try one or more of the following:
• Remove Tray 1.
• Open the front door, and then remove the photoconductor kit and toner cartridge.
2 Remove the jam.
3 Replace the photoconductor kit and toner cartridge if you removed it.
4 Close any open doors or trays.
5 Press to continue printing.
Troubleshooting 183