Lanier AP3200 - Manual (Page 93)

Replacing the Photoconductor Unit
79
4
K
Push the unit into the printer unit
it clicks into place.
L
Remove the red sheet from the
photoconductor unit and remove
the two pieces of tape.
M
Close the right cover of the print-
er.
Note
❒ If the right cover of the printer
cannot be closed, it means that
the photoconductor unit has not
been properly installed. Slide
the photoconductor unit out
and push it into the printer
again until it clicks into place.
N
Close the front cover.
O
If the duplex unit is installed,
close the duplex unit .
P
Turn on the printer.
After one minute, the display ap-
pears.
ZAEM370E
ZAEM410E
ZAEM310E
ZAEM380E
ZAEP270E