Lanier AP3200 - Manual (Page 61)

Error & Status Messages on the Operation Panel
47
4
Note
❒ If you cannot solve the problem by taking above actions, turn the power off
and then back on again. If this does not clear the error message, write down
the error number and the message, and contact your sales or service represen-
tative.
Replace
PCU
It is time to replace Photo Con-
ductor Unit Type 320. Replace Photo Conductor Unit
Type 320.
⇒ P.77 “Replacing
the Photoconductor Unit”
Reset Duplex
Unit Correctly AD380 (duplex unit) is not set
correctly. Set AD380 (duplex unit) cor-
rectly.
Reset Fusing
Unit Correctly
There is no fusing unit, or the
fusing unit is not installed
properly. Install the fusing unit proper-
ly. For more information
about the fusing unit, see the
"Maintenance Kit Type 270
Replacement Guide" that
comes with the kit.
Reset PCU
Correctly
There is no Photo Conductor
Unit Type 320, or Photo Con-
ductor Unit Type 320 is not in-
stalled properly. Install Photo Conductor Unit
Type 320 again. For more in-
formation about Photo Con-
ductor Unit Type 320, see the
"Photo Conductor Unit Type
320 Replacement Guide" that
comes with the photoconduc-
tor unit.
Resetting Job... Resetting print job. Wait for a while.
Reset Tray#
Correctly
There is no paper tray, or the
indicated tray is not set cor-
rectly.
# : Tray Number
Note
❒ This message appears only
for the default tray.
⇒ P.99
“Job Control Parameters”
Set the tray correctly.
Setting Changed
Cannot Print
The paper feed unit setting has
been changed, and the sample
print failed. Configure the paper feed unit
correctly, and try again.
Waiting... Printer is waiting for the next
data to print. Wait for a while.
Warming Up... The printer is now preparing
for printing. Wait until the printer is
warmed up.
Messages Description Comments