Lanier AP3200 - Manual (Page 92)

Troubleshooting
78
4
E
While pressing the green button,
slide the photoconductor unit out
until it stops.
F
Raise the green handle and slide
the photoconductor unit out to-
wards you.
Important
❒ Do not tilt or drop the removed
photoconductor unit. Moving
the unit abruptly can scatter
toner.
❒ While the photoconductor unit
is removed, do not change the
toner.
G
Take the new photoconductor
unit from the box and remove the
plastic bag, holding the handle.
Important
❒ Do not drop or damage the re-
moved photoconductor unit.
❒ Do not touch the side of the
photoconductor unit.
H
Put the photoconductor unit re-
moved in step
FFFF into the plastic
bag emptied in step
GGGG, keeping
the unit at the same angle as when
it was installed. Then, zip the
plastic bag.
I
Remove the two red sheets from
the photoconductor unit in the or-
der shown in the illustration.
Important
❒ Remove the photoconductor
unit keeping the unit parallel to
the ground as shown in the il-
lustration or the toner in the
unit might scatter.
❒ Do not touch the inside of the
unit or the green parts, after the
black protection sheet is re-
moved.
J
Align the new photoconductor
unit onto the rail of the printer.
Slide the unit all the way into the
printer.
ZAEM330E
ZAEM340E
ZAEM350E
ZAEM360E