Lanier AP3200 - Manual (Page 73)

Printer Does Not Print
59
4
If you print using the Post-
Script driver, printing
does not start or is inter-
rupted. The data is cleared when the Job Timeout period is exceeded.
❖ ❖ ❖ ❖ Windows 95/98/Me
Set a longer [Job Timeout] period with the [PostScript] tab of the
Printer Properties.
❖ ❖ ❖ ❖ Windows 2000
Set a longer [Job Timeout:] period with the [Device Settings] tab
of the Printer Properties.
❖ ❖ ❖ ❖ Windows NT 4.0
Set a longer [Job Timeout] period with the [Device Settings] tab of
the Printer Properties.
❖ ❖ ❖ ❖ Macintosh
Set a longer [Job Timeout] period.
A PostScript error might occur if there is not enough memory in
the printer, or there are errors in the print data sent to the printer.
• Print a configuration page to configure the memory size and
confirm the memory size is max or not.
• If the memory size is not the maximum, increasing the memory
may solve this problem. Install Memory Unit TypeB. Other-
wise you should contact your sales or service representative.
For more information about the memory, see P.113 “Functions
That Require Options”.
The print job might be reset. Do the following.
• Confirm that you have selected the correct printer driver. Try
printing again.
• Set a longer Wait Timeout.
❖ ❖ ❖ ❖ Windows 95/98/Me
Set a longer [Wait Timeout] period with the [PostScript] tab of
the Printer Properties.
❖ ❖ ❖ ❖ Windows 2000
Set a longer [Wait Timeout:] period with the [Device Settings]
tab of the Printer Properties.
❖ ❖ ❖ ❖ Windows NT 4.0
Set a longer [Wait Timeout] period with the [Device Settings]
tab of the Printer Properties.
❖ ❖ ❖ ❖ Macintosh
You can specify a longer “I/O Timeout” period on the op-
eration panel.
⇒ P.93 “Using the Operation Panel”
Possible Cause Solutions