Konica Minolta DiMAGE E201 - Manual (Page 91)

- 91 -
To play images back, the camera must be turned off and the LCD monitor activated. To
activate the LCD monitor, press and hold the display/enter button.
Problem Symptom Cause Solution
The LCD monitor
will not activate.
Nothing dis-
played on the
data panel.
Auto-power-off function
has shut off the camera
The batteries are dead.
The batteries are inserted
incorrectly.
The AC adaptor is not
connected properly.
Press and hold the dis-
play/enter button until the
monitor activates (p. 21).
Replace batteries
(p. 15).
Reinsert the batteries tak-
ing care that the negative
and positive terminals are
orientated as indicated on
the inside of the battery
chamber door (p. 20).
Check that the adaptor is
connected to the camera
and a live electrical outlet
(p. 22).
The LCD monitor
has turned off.
Nothing dis-
played on the
data panel
Cannot access
the camera from
the computer.
Nothing dis-
played on the
data panel or
LCD monitor.
Auto-power-off function
has shut off the camera
Television image
has a lot of static
and noise.
Camera is set to the
wrong video standard.
Set the correct standard for
the region on the setup
menu
(p.72 - 75).
Cannot use
enlarged play-
back with image.
Image was recording with
the digital zoom and at
half-image size
(p. 54).
The image file is
corrupt.
The CompactFlash card
was removed while the
camera was accessing the
card. Never remove a
CompactFlash card while
the green focus lamp is
blinking.
If the camera does not function normally, turn it off, remove and reinsert the batteries,
or unplug and reconnect the AC adaptor. Always turn the camera off using the lens-
cover slide (recording mode) or the display/enter button (playback mode) otherwise the
CompactFlash card may be damaged and camera settings reset.
Turn on the camera using
the lens-cover slide or dis-
play/enter button (p. 21).
TROUBLESHOOTING - Playback Mode