Kohler Aegis TP-2509 - Manual (Page 64)

8.14
Section 8
Electrical System and Components
Figure 8-21. Retaining Ring Detail.
5. Remove the commutator end plate assembly,
containing the brush holder, brushes, springs, and
locking caps. Remove the thrust washer from
inside the commutator end. See Figure 8-17.
Figure 8-17. Removing Commutator End Plate
Assembly.
6. Remove the frame from the armature and drive
end cap. See Figure 8-18.
Figure 8-18. Starter Frame Removed.
7. Remove the drive lever pivot bushing and backing
plate from the end cap. See Figure 8-19.
Figure 8-19.
8. Take out the drive lever and pull the armature out
from the drive end cap. See Figure 8-20.
9. Remove the thrust washer from the armature
shaft. See Figure 8-20.
Figure 8-20. Armature and Lever Removed.
10. Push the stop collar down to expose the retaining
ring. See Figure 8-21.