Kohler Aegis TP-2509 - Manual (Page 135)

11.31
Section 11
Reassembly
11
Figure 11-102. Rechecking Governor Linkage
Adjustment.
4. After adjustment is correct, reinstall the black
bushing and linkage into the governor lever.
Install Muffler
1. Install the muffler or exhaust system to the
exhaust port studs. Torque hex. flange nuts
to 24.4 N·m (216 in. lb.). See Figure 11-103.
Figure 11-103. Installing Muffler.
Install Oil Filter
1. Prefill the oil filter following the instructions in
Section 6.
2. Apply a thin coating of engine oil to the rubber
gasket of the oil filter and thread the filter onto the
adapter nipple.
3. Hand tighten the filter until the rubber gasket
contacts the adapter, then tighten the filter an
additional 2/3-1 turn. See Figure 11-104.
Figure 11-105. Install Oil Drain Plug(s).
NOTE: Make sure that both oil drain plugs are
installed and torqued to the above
specifications to prevent oil leakage.
2. Add oil of the proper viscosity to bring it up to the
‘‘Full’’ mark on the dipstick.
3. Install the dipstick into the tube.
Fill Cooling System
NOTE: To prevent engine damage, do not use anti-
freeze mixture with more than 70% ethylene
glycol in the cooling system. Do not use anti-
freeze with stop-leak additive(s) or mix/add
other additives to the cooling system. Cooling
system capacity is approximately 1.4 liters
(1.47 qt.).
Figure 11-104. Installing Oil Filter.
Fill Crankcase with Oil
1. Install the oil drain plug(s). See Figure 11-105.
Torque the plug(s) to 13.6 N·m (120 in. lb.).