Symbol Technologies VRC 6940 - Manual (Page 79)

A-20
VRC 6940 Product Reference Guide
Rate Control
To configure the Rate Control:
1. Select Rate Control to display the screen shown in Figure A-24 .
2. Use the UP or DOWN arrow keys to select 1Mb only, 2Mb only, or 1Mb and 2 Mb
options, then press ENTER. For Spring protocol, 1Mb is the only choice.
Figure A-24. Setting the Rate Control
Scanner/RF Operation
To configure the Scanner/RF operation:
1. Select Scan/RF Op to display the screen shown in Figure A-24 .
2. Use the UP or DOWN arrow keys to select Concurrent Op or Scan stops RF . Then
press ENTER.
If you want an attached scanner and the radio to both operate at the same time, select
Concurrent Op. If you want radio operation to be suspended during a scan, select
Scan stops RF.
Figure A-25. Setting Scanner/RF Operation
RATE CONTROL
TX Rate:
1 MB only
BkSp, CLR, Enter
SCAN/RF OP
Select Op Mode:
Concurrent Op
BkSp, CLR, Enter