Symbol Technologies VRC 6940 - Manual (Page 72)

A-13
Utilities and Diagnostic Tests
The Configurator Menu
The Configurator menu appears the first time
you start the terminal, or if you launch the
CFG24 program without parameters.
Figure
A-12 shows Configurator menu options.
Note that some terminals do not allow you to
change the
Subnet Mask , Default Router , and
Terminal IP addresses.
If you are using Spectrum24 802.11 protocol-
based software, the menu shows the ESS ID
option. For Spectrum24 Spring protocol-
based software, the menu shows Net ID.
Figure A-12. The CFG24 Configurator Menu
View Config Parameters
The View config option shows the terminal’s IEEE address, IP address, firmware version
number, and ESS ID or Net ID. To display the existing configuration parameters:
1. Select View config. Figure A-13 shows an example of the screen that appears.
2. Press CLEAR or ENTER to return to the Configurator menu.
Figure A-13. Viewing Configuration Parameters
reverse video
Configuration Note: Navigating the Menus
To navigate through the menus:
• Press UP or DOWN arrow keys to scroll
through menu options.
• To select, highlight the menu option you
want, then press ENTER. A highlighted op-
tion shows up in reverse video .
• To erase part of an entry, press BACK.
• To return to a previous menu press CLEAR.
• To exit to a DOS prompt, return to the Con-
figurator menu and press CLEAR.
reverse video
CONFIGURATOR X.XX
View config
ESS Id
Subnet Mask
Default Router
MU IP Address
Diversity
CLR, Enter
^
^
VIEW CONFIG
Terminal IEEE addr
00:A0:F8:28:78:EF
MU IP Address
0.0.0.0
FW: V3.29 981116
Net ID=101
CLR, Enter