Symbol Technologies VRC 6940 - Manual (Page 25)

3-2
VRC 6940 Product Reference Guide
Configuring a Spectrum24 Radio Card
To configure a Spectrum24 radio card.
1. Provide a reliable power source.
If you have not already done so, install the terminal hardware and provide a reliable
power source as described in Chapter 2. If the terminal is mounted in a vehicle, it can
remain mounted as long as the internal battery is fully charged (see
page 2-8 ) and
you can position it close enough to the host PC for the cables to reach. Otherwise,
remove it from the vehicle, position it on a workbench and provide operating power
with a Symbol AC universal power supply.
Note: If there is a power interruption during configuration, simply restore
the power and start again at step two (Start the Terminal).
2. Start the terminal.
The first time you power up a VRC 6940 terminal, press the ON/OFF key to start
the terminal, and let it run through a series of messages. The terminal loads essential
utilities and system drivers and displays the CFG24 Configurator utility as shown in
Figure 3-1 .
You can also start the CFG24 Configurator utility by typing CFG24 at a DOS
command line and pressing ENTER.
Figure 3-1. The CFG24 Configurator Utility
CONFIGURATOR X.XX
View config
ESS Id
Subnet Mask
Default Router
MU IP Address
Diversity
CLR, Enter
^
^