Symbol Technologies VRC 6940 - Manual (Page 38)

5-1
Chapter 5 Operating a VRC 6940
After you install and configure a VRC 6940 terminal for your facility, you can release it for
use. This chapter describes how to use the terminal, including:
! Powering the terminal On and Off
!
Resetting the terminal
! Adjusting brightness
! Entering data
!
Attaching a scanner
! Moving a terminal to different power source
! Booting into Command Mode
The instructions in this chapter assume that the terminal has been fully installed, configured,
and set up to run your facility’s software applications. For information on installing and
configuring a terminal, see Chapters 2, 3 and 4.