Check handset functionalities, Start up not successful, Check lan connection – Siemens HiPath 4000 User Manual
Page 91: Determine the software version
Check handset functionalities
Administration scenarios
91
Check handset functionalities
•
Check whether the plugs at the two ends of the handset cable are in-
serted correctly (handset engaged)
•
Carry out an Audio Loop test.
– More information on “Audio Loop Test“
–
•
Ensure that the handset microphone is not switched off.
– For more information, see the operating instructions of the
optiPoint 410/420.
Start up not successful
Check whether one or more of the mentioned questions are valid for your
configuration:
Is the optiPoint 410/420 being run in a
•
Enter the VLAN ID manually, or, if a
Æ DHCP server is being used, set
the “VLAN Method“
Æ page 81 on "DHCP" , so that the VLAN ID trans-
ferred from the DHCP server is used.
– More information on
Is the optiPoint 410/420 being run behind a
•
Enter the
Æ IP address of the Gateway in Æ Default Route.
Other configuration possibilities ...
Check LAN connection
•
Check whether the plugs at the two ends of the LAN cable are correct-
ly inserted (handset engaged)
•
Check the connection with the help of the PING test.
– More information on “PING Test“
Determine the software version
You can determine the version of the software that is running the
optiPoint 410/420, e.g., during a pending software update.