Seagate Fibre Channel Interface - Manual (Page 317)

Fibre Channel Interface Manual, Rev. D 303
12.46 Seek (10) command
The Seek (10) command requests that the disc drive seek to the specified Logical Block Address. This com-
mand is implemented with the disc drive specific parameters listed in Table 204.
Field definitions (listed alphabetically)
Control
See Control Bytes in Section 11.2.1.6.
Logical Block Address
This command operates the same as the Seek command (Section 12.45) except that a four-byte Logical Block Address is
specified.
Table 204: Seek (10) command (2Bh)
Bit
Byte
7 6 5 4 3 2 1 0
0 0 0 1 0 1 0 1 1
1 0 0 0 0 0 0 0 0
Reserved
2
Logical Block Address (MSB)
3
Logical Block Address
4
Logical Block Address
5
Logical Block Address (LSB)
6 0 0 0 0 0 0 0 0
7 0 0 0 0 0 0 0 0
8 0 0 0 0 0 0 0 0
9
Control
2Bh
Table
number
204
204