E 151 – Seagate Fibre Channel Interface User Manual
Page 242
228
Fibre Channel Interface Manual, Rev. D
12.13.6
Verify Error Recovery page (07h)
The Verify Error Recovery page specifies the error recovery parameters the target uses during the Verify com-
mand and the verify operation of the Write and Verify command.
Field definitions (listed alphabetically)
DCR (Disable Correction)
1
ECC correction will not be applied to the data even if correction is possible.
0
ECC correction will be applied if correction is possible.
DTE (Disable Transfer on Error)
The DTE bit is valid only when the PER bit is set to 1.
1
The disc drive terminates data transfer even for recoverable errors (the drive will transfer the data for the recovered
error before terminating the transfer).
0
Data transfer continues if recoverable errors are encountered. Recoverable errors are reported after all data has
been transferred.
Table 151: Verify Error Recovery page (07h)
Bit
Byte
7
6
5
4
3
2
1
0
Page descriptor header
0
1
0
Page Code (07h)
PS
Reserved
1
Page Length (0Ah)
Verify error recovery parameters
2
0
0
0
0
0
PER
DTE
DCR
Default
Reserved
EER
3 Default
Verify Retry Count
4 Default
Verify Correction Span (bits)
5
0
0
0
0
0
0
0
0
Default
Reserved
6
0
0
0
0
0
0
0
0
Default
Reserved
7
0
0
0
0
0
0
0
0
Default
Reserved
8
0
0
0
0
0
0
0
0
Default
Reserved
9
0
0
0
0
0
0
0
0
Default
Reserved
10
(MSB) 1
1
1
1
1
1
1
1
Default
Verify Recovery Time Limit
11
1
1
1
1
1
1
1
1 (LSB)
Default
Verify Recovery Time Limit
Table
number