Sanyo PCS Vision PM-8200 - Manual (Page 38)

End-of-Call Options
To display the following options, press Options (right softkey) within
10 seconds after disconnecting a call.
To select an option, highlight it and press .
ⅷ Call Again to dial the phone number.
ⅷ Call:Speaker On to dial the phone number in speakerphone mode.
ⅷ Save Phone# to save the phone number in your Contacts list.
Go to Phone Book appears when the number is already in your
Contacts list. (See “Saving a Phone Number” below.)
Note: The End-of-Call options are not displayed for calls identified as No ID or
Restricted.
Saving a Phone Number
Your Sanyo SCP-8200 Phone can store up to 500 phone numbers in
up to 300 Contacts entries (an entry may contain up to seven
numbers). Each entry’s name can contain 16 characters. Your phone
automatically sorts the Contacts entries alphabetically. (For more
information, see Section 2G: Using the Contacts Directory on page 86.)
To save a number from standby mode:
1. Enter a phone number.
2. Press Options (right softkey).
3. Highlight Save Phone# and press .
4. Select a label by highlighting Mobile, Home, Work, Pager, Fax,
Other, or No Label and press
.
5. Enter a name and press .
If you have already stored entries in the Contacts list, you are
prompted to select the following entry modes:
Ⅲ New Name to enter a new name.
Ⅲ From Ph. Book to select a name from the Contacts entry list.
6. Press Save (left softkey).
After you have saved the number, the new Contacts entry is
displayed. (See “Contacts List Entry Options” on page 90.)
Section 2A: Your Phone – The Basics 26