Sanyo PCS Vision PM-8200 - Manual (Page 165)

Setting the Flash Function
To activate the flash function:
1. With the phone open and in camera mode, press Options (right
softkey).
2. Select Flash and press .
3. Select an option from the following and press .
Ⅲ On This Shot to activate the flash for one shot.
Ⅲ On Always to activate the flash all the time.
Ⅲ Auto to activate the flash automatically.
4. Take a picture using the phone’s main LCD as a viewfinder.
Ⅲ To deactivate this feature, select Off during step 3.
Tip: When the phone is open and in camera mode, press to switch
between flash modes.
Setting the Self-timer
To activate the Self-timer:
1. With the phone open and in camera mode, press Options (right
softkey).
2. Highlight Self-timer and press .
3. Highlight the length of delay you want the timer to use
(10 seconds or 5 seconds) and press
.
4. Press Start (left softkey) when you are ready to start the timer.
(
appears on the lower left portion of the main LCD during
the Self-timer countdown.)
5. Get ready for the picture. (When the timer is down to three
seconds, the Self-timer icon will turn red and the phone will
begin to beep.)
Note: After taking a picture, Self-timer settings return to their default settings.
To cancel the Self-timer after it has started:
ᮣ Press Cancel (right softkey).
Note: While the Self-timer is active, all keys are disabled except , , and
Cancel (right softkey).
Section 2K: Using Your Phone’s Built-in Camera 153