Siemens Hicom 300 E - Manual (Page 91)

Making calls in an executive/secretary team
91 91 91 91
Step by Step
Using the call signal function
If a call signal key has been configured on your execu-
tive telephone you can generate a call signal on a partic-
ular destination telephone (for example, in the secre-
tary's office) by pressing this key. When a call signal is
received the number of the calling telephone is dis-
played b riefly on the destination telephone.
The key can be pressed (once or several times) when
the phone is idle or while a call is in progress.
If the Call Signal function has not been configured, you
can generate a call signal at a destination telephone by
lifting the handset and entering the call-signal code
number.
Designating a deputy for the secretary
The calls for the executive that are normally received in
the secret ary’s office can b e diverted to a different tele-
phone. A Function Transfer key must be configured for
this purpose. The proced ure is the same as described
in the section "Saving a repertory dialing number on a
key" (
Æ page 48) - in this case for a deputy.
To activate deputy:
Press the key. The lamp lights up.
To deactivate deputy:
Press the key. The lamp goes out.
All about the telephone
Deputy
Deputy