Siemens Hicom 300 E - Manual (Page 58)

Step by Step
Forwarding calls
58 58 58 58
Outp ut on second line.
To select the next variable forwarding type.
Outp ut on first line.
Outp ut on second line.
or
To edit the current variable forwarding type.
Outp ut on first line.
Outp ut on second line.
Programming/changing the forwarding destination
Press the key. The lamp lights up .
Confirm.
Confirm. Display shows "Variable forwarding".
Confirm. Display shows "Fixed forwarding".
Confirm. Display shows "Forwarding for internal".
Op en a forwarding type, for examp le, "Forwarding for in-
ternal".
E
Enter the number of the forward ing destination. Any
d estination previously saved will be overwritten
Confirm when the complete number has been entered.
To select a different forwarding type, proceed as de-
scribed on
Æ page 57.
If variable forwarding was p reviously programmed and
activated, it is deactivated and the forwarding destina-
tion is deleted (for exception, see
Æ page 57). Fixed for-
warding is deactivated.
Deleting a forwarding destination
A variable forwarding destination is automatically delet-
ed when the forwarding type is switched off.
Activating variable forwarding
Variable forwarding is automatically activated when the
forwarding destination is programmed.
Next f orwardin g type? >
FWD- ALL- EXT o ff
Next f orwardin g type? >
FWD- ALL- INT o ff
E nter destination: >
Ser vice Menu
Destinatio ns?
Call forwarding?
Next f orwardin g type? >
Next f orwardin g type? >
Next f orwardin g type? >
E nter destination: >
Save?