Siemens Hicom 300 E - Manual (Page 67)

Using a different telephone in the same way as your own
67 67 67 67
Step by Step
Identification with the chip card
Precondition: You have been assigned a chip card by
System Suppor t for logon at other telephones. The
optiPoint 500 at which you wish to log on must be
equipped with a chip card reader (optiPoint 500 signa-
ture module).
W ithin your own HiPath 4000 or Hicom 300 E/H sys-
tem:
Insert the chip card. All lamps light up briefly.
"ID card" and the numb er of the home station are indi-
cated on the display.
or At another HiPath 400 0 or Hicom 300 E/H system in
the integrated network:
Insert the chip card.
E
Enter the node code for your own HiPath 40 00 or Hi-
com 300 E/H system (check with System Support).
EG
Enter your own number and press the pound key.
Deactivating identification at the other
telephone
If you logged on with a PIN:
Press the key. The lamp lights up.
??
Enter the service code.
or
Select and confirm.
Select and confirm.
If you logged on with a chip card:
Remove the chip card when the telep hone is in the idle
state.
Insert
chip card
Chip card
reader:
Ente r th e code !
Ser vice Menu
P IN / COS?
Deactivate PIN?
Identification is d eactivated automatically if the
other telephone is not used for several minutes.
Remove
chip card
Chip card
reader: