Sun Microsystems X1150A - Manual (Page 54)

32 Sun GigaSwift Ethernet Adapter Installation and User’s Guide • February 2003
■ Booting in non-Auto-Negotiated verbose mode at 100 Mbps full duplex:
■ Booting in non-Auto-Negotiated verbose mode at 1000 Mbps half duplex link-
clock master:
Note – For link to be successfully established the link partner must be configured to
1000 Mbps half duplex link-clock slave.
9. Proceed with the Solaris operating environment installation.
Refer to the Solaris Advanced Installation Guide for more information about installing
the Solaris operating environment over the network.
10. After installing the Solaris operating environment, install the Sun GigaSwift
Ethernet software on the client system.
The software installed in Step 4 was required to boot the client system over the
GigaSwift Ethernet interface. You now need to install the software in order for the
operating system to use the client’s GigaSwift Ethernet interfaces in normal
operation.
Before installing the Sun GigaSwift Ethernet software, make sure that the client
system does not already have the software installed. Use the
pkginfo command to
see if the Sun GigaSwift Ethernet software packages are installed on the client
system.
■ If the software is installed (as shown in the example above), skip to Step 11.
■ If the software is not installed, install the software from Solaris Supplement CD.
Refer to “Installing the Driver Software” on page 9 for instructions on installing
the required software packages.
ok boot /pci@1f,4000/network@4:speed=100,duplex=full, -v
ok boot /pci@1f,4000/network@4:speed=1000,duplex=half,link-clock=master
# pkginfo | grep SUNWce
system SUNWced Sun Gigabit Ethernet Adapter Driver
system SUNWcem Sun Gigabit Ethernet Adapter Driver Man Pages
system SUNWcedu Sun Gigabit Ethernet Adapter Driver Headers