List the network devices on your system, Rebooting the system – Sun Microsystems X1150A User Manual

Page 42

Sun GigaSwift Ethernet Adapter Installation and User’s Guide • February 2003

▼

To Set the GigaSwift Ethernet Device Primary Boot Device

Use this procedure only if you want the GigaSwift Ethernet device to be your
primary boot device.

1. List the network devices on your system.

2. Set the Sun GigaSwift Ethernet device to be your default boot device, type:

Note that the correct command has a space rather than

between

boot-device

and

/pci@1f,2000/pci@1/network@4

Rebooting the System

After verifying the adapter installation, use the

boot -r

command to perform a

reconfiguration boot on your system.

ok show-nets

a) /pci@1f,2000/pci@1/network@4

b) /pci@1f,4000/network@1,1

q) NO SELECTION

Enter Selection, q to quit: q

ok setenv boot-device /pci@1f,2000/pci@1/network@4

ok boot -r