List the network devices on your system, View the device that you installed – Sun Microsystems X1150A User Manual

Page 39

Chapter 2

Installing the Adapter

2. List the network devices on your system.

Use the

show-nets

command to list the system devices. You should see the full

path name of the

network

devices, similar to the Ultra 30 system example below. In

this example, the

network@4

device is the Sun GigaSwift Ethernet adapter and the

network@1,1

is the onboard Ethernet device.

Note –

If you do not see the device listed, check that the adapter is properly seated

and, if necessary, reinstall the adapter.

3. View the device that you installed.

Using the previous example, type:

Be sure to write down your device path, which in the example is

/pci@1f,0/pci@1/network@4

. While your device path may be different, it will be

similar. You will need this information to make changes to the

ce.conf

file. See

ok show-nets

a) /pci@1f,2000/pci@1/network@4

b) /pci@1f,4000/network@1,1

q) NO SELECTION

Enter Selection, q to quit: q

ok cd /pci@1f,0/pci@1/network@4