Sun Microsystems X1150A - Manual (Page 45)

Chapter 2 Installing the Adapter 23
Now the system is also aware of the usable devices which reside on the adapter and
all devices may be mounted or configured to be used.
If the command fails to connect and configure the adapter and slot (the status should
be shown as “configured” and “ok”), do the connection and configuration as
separate steps:
a. Connect the adapter and slot:
The states and conditions for a connected attachment point should be:
Now the system is aware of the adapter, but not the usable devices which reside
on the adapter. Temperature is monitored and power and cooling affect the
attachment point condition.
b. Configure the adapter and slot:
The states and conditions for a configured attachment point should be:
Now the system is also aware of the usable devices which reside on the adapter and
all devices may be mounted or configured to be used.
7. Reconfigure the devices on the adapter
The console should now display a list of devices and their addresses.
# cfgadm -v -c connect sysctrl#:slot#
Receptacle state—Connected
Occupant state—Unconfigured
Condition—OK
# cfgadm -v -c configure sysctrl#:slot#
Receptacle state—Connected
Occupant state—Configured
Condition—OK
# drvconfig; devlinks; disks; ports; tapes;