Type the following to apply and save your changes, To set autonegotiation to – Sun Microsystems X1150A User Manual
Page 101
Appendix B
Diagnostic Software and Troubleshooting Issues
77
2. At the
Main#
prompt, type
cfg
to display the Configuration menu and prompt
(
Configuration#
).
3. Type the following to disable autonegotiation on a GigaSwift Ethernet port.
Replace portnumber with the Ethernet port used by the adapter.
4. Type the following to apply and save your changes.
Refer to the switch documentation for further configuration instructions.
▼
To Set Autonegotiation to
off
for Other
Noncompliant Network Equipment
If your network equipment does not support autonegotiation, you can set
autonegotiation to
off
on the GigaSwift Ethernet (
ce
) device.
1. Set the following GigaSwift Ethernet driver parameters to values according to the
documentation that shipped with your switch:
■
adv-1000fdx-cap
■
adv-1000hdx-cap
■
adv-ampause-cap
■
adv-pause-cap
>> Main# cfg
[Configuration Menu]
sys
-
System-wide parameter menu
port
-
Port configuration menu
ip
-
IP addressing menu
vlan
-
VLAN configuration menu
stp
-
Spanning Tree menu
snmp
-
SNMP menu
setup -
Step by step configuration set up
dump
-
Dump current configuration to script file
>> Configuration#
>> Configuration# /port
portnumber
/auto off
>> Configuration# apply
>> Configuration# save