Sun Microsystems SERVER 1290 - Manual (Page 57)

Chapter 2 Setting Up 45
2. At the Enter new password prompt, type your password.
3. At the Enter new password again prompt, re-type your password.
If your password has been lost or forgotten, contact Sun Service for assistance.
▼ To Configure Network Parameters
The Netra 1290 server can be administered from the SC LOM prompt and from the
Solaris software. There are two ways to access the LOM console connection:
■ Through the SC serial port connection
■
Through a remote (network) connection using the 10/100BASE-T Ethernet port
Note – The system can be administered solely through the serial port, but if you
want to use the 10/100BASE-T Ethernet port, use a separate secure subnet for this
connection. Remote connection capability is not enabled by default. If you use SSH
or Telnet to administer the system, you must set the connection type to SSH or
Telnet, using the
setupnetwork command.
1. At the LOM prompt, type setupnetwork.
2. Answer the questions in the script.
Note – If you press the Return key after each question, the current value will not be
changed.
See the Sun Fire Entry-Level Midrange System Controller Command Reference Manual,
819-1268 for full details of the
setupnetwork command. CODE EXAMPLE 2-1 shows
an example of the setupnetwork command.
lom>password
Enter new password:
Enter new password again:
lom>
lom>setupnetwork