Sun Microsystems SERVER 1290 - Manual (Page 17)

Chapter 1 Unpacking and Installing the Server 5
This section is divided into the following:
■ “Adjusting the Slide Rail Assembly” on page 5
■ “To Install the Inner Rails on the Server” on page 6
■
“To Prepare the Rails for 2-Post Installations” on page 8
■
“Installing the Slide Rail Assemblies in a Sun Fire or Sun StorEdge Cabinet” on
page 9
■ “Installing the Slide Rail Assemblies in a Sun Rack 900 Cabinet” on page 11
■ “Installing the Slide Rail Assemblies in a 19-Inch 4-Post Cabinet” on page 13
■ “Installing the Slide Rail Assemblies in a 19-Inch 2-Post Rack” on page 14
Adjusting the Slide Rail Assembly
Each slide rail assembly consists of four components ( FIGURE 1-3 ):
■
Rear bracket that attaches to the assembly
■ Adjustable bracket that attaches to the rear bracket (adjustable bracket is not used
in some configurations)
■ Slide rail assembly (with inner and outer rails)
■ Front bracket
FIGURE 1-3 Slide Rail Assembly (Standard Configuration)
2-Post 3" Position
2-Post 4" Position
2-Post 6" Position
S un f ir e C a bi n et
N GR Ca b in e t
S to r ed g e C ab i ne t
Adjustable
Rear
Front
Slide rail S
U
N
F
I
R
E
bracket
assembly
bracket
bracket