Woodstock M1013 - Manual (Page 29)

-27-
M1013 Owner's Manual (Mfg. Since 6/09)
SE
RV
IC
E
SERVICE
This section covers the most common service adjustments
or procedures that may need to be made during the life
of your machine.
If you require additional machine service not included
in this section, please contact Woodstock International
Technical Support at (360) 734-3482 or send e-mail to:
[email protected].
General
MAKE SURE that your machine is
unplugged during all service proce-
dures! If this warning is ignored, seri-
ous personal injury may occur.
Blade Change
Change the blade when it becomes dull, damaged, or
when you are using materials that require a blade of a
certain type or tooth count.
To change the bandsaw blade, do these steps:
1. DISCONNECT BANDSAW FROM POWER!
2. Hold the headstock, un-attach the feed cylinder by
removing the cap screw, then raise the headstock to
the full vertical position (see Figure 31).
3. Push the safety stop in, use a screwdriver to remove
the upper and lower blade guide guards, and loosen
the blade guides (see Figure 32).
Figure 31. Feed cylinder cap screw.
Feed Cylinder
Cap Screw
Figure 32. Blade guide guards and
fasteners.
Safety
Stop
Blade
Guide
Guards
Guide
Bolt
Guide
Knob