Woodstock M1013 - Manual (Page 22)

-20-
M1013 Owner's Manual (Mfg. Since 6/09)
SE
TU
P
Once the assembly is complete, test run your machine to
make sure it runs properly.
If, during the test run, you cannot easily locate the
source of an unusual noise or vibration, stop using the
machine immediately, then review the Troubleshooting
on Page 32.
If you still cannot remedy a problem, contact our Tech
Support at (360) 734-3482 for assistance.
To test run the machine, do these steps:
1. Make sure you understand the safety instructions
at the beginning of the manual, and verify that the
machine is setup properly.
2. Ensure all tools and objects used during set up are
cleared away from the machine.
3. Connect the machine to the power source.
4. Start the bandsaw while keeping your finger near
the ON/OFF switch at all times during the test run.
The bandsaw should run smoothly with little or no
vibration.
— Strange or unusual noises should be investigated
and corrected before operating the machine
further. Always disconnect the machine from
power when investigating or correcting potential
problems.
5. Turn the machine OFF.
Test Run
Projectiles thrown from the machine
could cause serious eye injury. Wear
safety glasses to reduce the risk of
injury.
Loose hair and clothing could get
caught in machinery and cause serious
personal injury. Keep loose clothing
rolled up and long hair tied up and
away from machinery.