Woodstock M1013 - Manual (Page 12)

-10-
M1013 Owner's Manual (Mfg. Since 6/09)
SE
TU
P
Keep machine disconnected from
power until instructed otherwise.
This machine has been carefully packaged for safe
transportation. If you notice the machine has been
damaged during shipping, please contact your authorized
Shop Fox dealer immediately.
Unpacking
SETUP
The following is a description of the main components
shipped with the Model M1013. Lay the components out to
inventory them.
Note: If you can't find an item on this list, check the
mounting location on the machine or examine the
packaging materials carefully. Occasionally we pre-install
certain components for safer shipping.
Inventory (Figure 3) Qty
A. Base ..........................................................1
B. Front Panel .................................................1
C. Rear Panel ..................................................1
D. Right Panel .................................................1
E. Left Panel ...................................................1
F. Chip Tray ....................................................1
G. Feet ..........................................................4
H. Axle ..........................................................1
I. V-Belt ........................................................1
Inventory
J. Belt Cover .................................1
K. Work Stop ..................................1
L. Work Stop Shaft ...........................1
M. Wheels .....................................2
Assembly Hardware (Not Shown):
—Knob Bolt 1 ⁄
4
"-20 x 5 ⁄
8
" (Pulley Cover) ...1
—Hex Bolt M8-1.25 x 30 (Saw-Cabinet) ....4
—Flat Washer 17mm (Wheels) ...............4
—Cotter Pin 1 ⁄
8
" x 1" (Wheels) ...............2
—Hex Bolts M8-1.25 x 16 (Cabinet) ....... 16
—Hex Nuts M8-1.25 (Cabinet) .............. 16
—Flat Washer 8mm .......................... 32
—Hex Bolt 1 ⁄
4
"-20 x 1 ⁄
2
" .......................2
—Flat Washer 1 ⁄
4
" ..............................3
Figure 3. Model M1013 inventory.
A
B
C
D
E
F
G
M
H
L
K
I
J