Siemens HIPATH 20 - Manual (Page 21)

inbetriebnahme.fm
A31003-O1010-M100-9-76A9, 05/05/2008
HiPath 8000 - OpenStage Family, Administration Manual
2-5
Startup
Assembling and Installing the Phone
2.2.4 Connecting the Phone
1. Plug the LAN cable into the connector at the bottom of the telephone and connect the
cable to the LAN resp. switch. If PoE (Power over Ethernet) is to be used, the PSE (Power
Sourcing Equipment) must meet the IEEE 802.3af specification.
For details about the required power supply, see the following table:
2. Only if Power over Ethernet (PoE) is NOT supported:
Plug the power supply unit into the mains. Connect the plug-in power supply unit to the
jack at the bottom of the phone.
Model Power Consumption/Supply
OpenStage 20 Power Class 1
OpenStage 20 G Power Class 2
OpenStage 40
1
1 Includes 1 Key Module.
Power Class 2
OpenStage 40 + 2nd Key Module Power Class 3
OpenStage 40 G
1
Power Class 3
OpenStage 40 G + 2nd Key Module External power unit required
OpenStage 60/80
2
2 Includes 1 Key Module + USB-Extension with Acoustic Unit.
Power Class 3
OpenStage 60/80 + 2nd Key Module Power Class 3
OpenStage 60/80 G
2
Power Class 3
OpenStage 60/80 G + 2nd Key Module External power unit required
Tabelle 2-1
7
Use only the plug-in power supply unit fitting the OpenStage phone:
EU: C39280-Z4-C510
UK: C39280-Z4-C512
USA: C39280-Z4-C511