Siemens HIPATH 20 User Manual
Page 107
administration.fm
A31003-O1010-M100-9-76A9, 05/05/2008
HiPath 8000 - OpenStage Family, Administration Manual
3-65
Administration
Multiline Appearance/Keyset
•
"none": To answer a call, the user manually selects a line by pressing its line key before
going off-hook, or by pressing the speaker key. Manual line selection overrides auto-
matic line preferences.
Line action mode determines the consequence for an established connection when the line
key is pressed. If "hold" is selected, the call currently active is set to hold as soon as the line
key is activated. The user has two options: 1) to reconnect to the remote phone by pressing the
line key that corresponds to that call, or 2) to initiate another call from the newly selected line.
If "release" is selected, the previously established call is ended.
If Show Focus is checked, the LED of a line key flutters when the line is in use. If it is not
checked, the line key is lit steady when it is in use.
The Reservation timer sets the period after which the reservation of a line is canceled. A line
is automatically reserved for the keyset whenever the user has selected a line for an outgoing
call and hears a dial tone. The reservation of a line is accomplished by the HiPath 8000 server,
which notifies all the endpoints sharing this line. If set to 0, the reservation timer is deactivated.
Forward indication activates or deactivates the indication of station forwarding, i. e. the for-
warding function of the HiPath 8000. If Forward indication is activated and station forwarding
is active for the corresponding line, the LED of the line key blinks.
Preselect mode determines the phone’s behaviour when a call is active, and another call is
ringing. If the parameter is set to "Single button", the user can accept the call a single press on
the line key. If it is set to "Preselection", the user must first press the line key to select it and
then press it a second time to accept the call. In both cases, the options for a ringing call are
presented to the user: "Accept", "Reject", "Deflect".
Preselect timer sets the timeout for an incoming call. After the timeout has expired, the call is
no longer available.
Data required
•
Rollover ring: Determines if a ringtone will signal an incoming call while a call is active.
Value range: "No ring", "Alert beep", "Alert ring".
Default: "Alert beep".
•
LED on registration: Determines if line LEDs will signal SIP registration.
Value range: "Yes", "No".
Default: "Yes".
•
Originating line preference: Selects the line to be used for outgoing calls.
Value range: "Idle line", "Primary", "Last", "None".
Default: "Idle line".
•
Terminating line preference: Determines which line with an incoming call shall be select-
ed for answering.
Value range: "Ringing line", "Incoming", "Incoming PLP", "Ringing PLP", "None".
Default: "Idle line".