SVAT Electronics 2CV500 - 4CH - Manual (Page 55)

55 CV500 - 4CH
IP Setting
DHCP/Static: Choose whether your network uses DHCP IP address or a Static IP address. Generally most networks user DHCP
automatically assigned IP addresses. See NETWORK SETUP for more information regarding DHCP/STATIC IP
addresses.
• If a DHCP IP address is configured is likley the IP address will change and require a port forwarding rule change
• Once assigned a DHCP address it is recommended to change the IP assignment to static to avoid this switch
The information regarding the Static IP address can be obtained from the person who set up your network.
Port Assignment
Web Page Port: The port that is used to access the DVR over the web. By default (without specifying) Internet browsers
automatically add :80 to the end of IP addresses. If using a web port other than 80 it will need to be specified when
typing in the IP address.
RTSP Port: (Real Time Steaming Protocol) Used by mobile devices to view a single camera. Type the following into the URL
search of your mobiled device. The syntax for viewing the camera channels on a mobile device is RTSP://IPADDRESS/
CH0# . By default the RTSP port is 554.
RTP START/END Port: (Real-time Transfer Protocol) used in conjunction with the RTSP port to view the steaming video footage on the
mobile device. Each connected device using the RTSP port requires an additional 4 RTP ports. Please refer to the
PORT FORWARDING section of the manual for more details.
Apply: Used to apply all the IP settings.
NETWORK VIEWING & PLAYBACK...continued
PPPoE
Enabled/Disabled: If your DSL Internet Service Provider prompts you to enter a Username and Password to connect to the Internet then
this option needs to be set to enabled. Consult with your ISP if you are not sure if you need your PPPoE settings.
Username: Your PPPoE account username can be acquired from your ISP if required.
Password: Your PPPoE account password can be acquired from your ISP if required.
Send mail after dialed
Enabled: This will email the email address set up in the Mail & FTP section when the DVR dials in to the PPPoE server. Every
time the DVR dials in it will acquire a new external IP address (Unless statically assigned by your ISP). The email will
include the Subject: from the field below as well as information regarding the new connection. This will include the
new IP address.
Load Default
Load Setup From Default (Setting): Applies factory default settings. You will be prompted to confirm the restore.
Load Setup From: (Browse):
Browse to the location where the system configuration settings are stored.
Load Setup From: (Setting): Applies the configuration settings from the backup file.
Backup Setup (Download): Prompts you to save the current configuration settings to your computer. Click save and choose
the location to save your settings.
NETWORK VIEWING & PLAYBACK...continued
NETWORK OPTIONS