SVAT Electronics 2CV500 - 4CH - Manual (Page 14)

14 CV500 - 4CH
Note: If the monitor has multiple video inputs then the video source will need to be switched to watch the DVR. Example: If the DVR
is connected to Video 2 then press the TV/Video, Input, or Source button on the TV/Monitor to switch to Video 2.
1. Connect a BNC to RCA connector to
the MONITOR OUT connection on the
back of the DVR. 2. Plug the RCA cable into the BNC
connector. 3. Attach the other end of the RCA cable to a
yellow RCA video input on your monitor.
4. Switch the TV/Monitor source to view the DVR.
CONNECTING A MONITOR TO THE DVR (RCA COMPOSITE)
CONNECTING ADDITIONAL DEVICES TO THE DVR...continued
CONNECTING YOUR ALARM SYSTEM TO THE DVR
The CV500-4CH allows you to connect up to four external alarm devices
simultaneously. Please see your alarm device manufacturer for further instructions
on required connections and settings. The DVR supports a 2 wire (normally open or
normally closed) connection.
To connect a two wire alarm:
1. With a small object such as a flat head screwdriver push the orange tab
back away from the circular opening.
2. Insert the wire into the hole below the orange tab while it is still
pushed back.
3. Release the orange tab, which will lock the wire into place. Pull lightly
on the wire to make sure it is secure.
1.
2.
3.