SVAT Electronics 2CV500 - 4CH - Manual (Page 23)

23 CV500 - 4CH
ALARM RECORD PPS
You can change the PPS for alarm record. You may wish to change
the alarm PPS so that there is a higher PPS for when an alarm (e.g.
motion) is detected by the DVR and a lower PPS for
Normal Record.
To Change the Alarm Record PPS:
1. Select to adjust the Alarm Record PPS.
2. Use the mouse wheel or the directional buttons to adjust the PPS.
3. When in 720 x 240, you can change each camera’s PPS.
4. When in 360 x 240 the normal PPS for CH1 and CH2 will change together, as will CH3 and CH4.
5. Press ENTER or select to save settings and return to Record Setup Menu.
6. Exit the Record Setup Menu to save changes.
7. Exit the Main Menu to save changes. The DVR will take a few moments to load the settings.
• There is a total of 120 PPS (for 360 x 240) available to share between the 4 channels.
• There is a total of 60 PPS (for 720 x 240) available to share between the 4 channels
Note: By clicking the box next to the word ‘AVERAGE’ you can evenly distribute the PPS to all cameras for Normal PPS and Alarm
Record PPS
MAIN MENU...continued
AUDIO RECORD
The DVR is capable of recording one channel of audio. You can connect a camera that has a built in microphone or connect an external microphone
into the RCA audio input to configure the DVR to record with audio.. The cameras that are included with the DVR do not support audio.
To record with audio:
1. Highlight the Audio Record option.
2. Use the mouse wheel or directional keys to change from OFF to ON.
3. Press ENTER or Click the to save changes.
4. Exit the Main Menu to save changes. The DVR may take a few moments to load the settings.
Using the Pop Up Menu Bar you can mute the audio from playing through the connected speaker or TV and still record.