SVAT Electronics 2CV500 - 4CH - Manual (Page 12)

12 CV500 - 4CH
• The camera should be installed between 8 and 13ft above the area to be monitored
• Ensure there are no obstructions in the camera’s view, to maximize viewing area
• Ensure that the sunshade is positioned to avoid glare and position camera away from direct sunlight or indoor lighting
• Decide whether the camera will be wall-mounted, ceiling mounted or sit on a desk/table top. If you are mounting the camera on a wall or
ceiling, use the mounting hardware in the package. We recommend that the mounting bracket is secured using the included screws for all
installations
• This camera comes with 60ft of video/power wire. Please make sure that you mount the cameras no more than 60ft from the TV/monitor/
VCR/DVR. If longer wiring distance is required, 60 ft extensions can be purchased (CVW62) from your local reseller or at
www.SVAT.com
• We recommend using a surge protected power bar to protect the cameras internal circuitry
THINGS TO CONSIDER BEFORE INSTALLATION
CAMERA INSTALLATION
MOUNTING
1. Decide if the camera will be wall-mounted or sit on a desk/tabletop. The camera can be
adjusted for either mounting scenario by rotating it to the required position.
2. Screw the mounting bracket into the camera’s mounting hole, turning it clockwise.
3. Mount the camera in the desired location no more than 60 ft from the DVR unless you
have purchased additional wiring. You may wall, ceiling or desk mount these cameras.
4. Adjust cameras to the desired viewing angles.
3. Plug the camera’s
power adapter into an
AC outlet.
4. Attach the BNC to
RCA connectors to
one of the video
inputs on the back
of the DVR.
1. Plug the 4 PIN DIN
female connection on
the camera into the
4 PIN DIN male
connection on the 60ft
video/power wire.
WIRING
2. Plug the included four
port power supply
into the camera power
adapter then into the
red power jack located
on the 60 ft video/
power wire.