SVAT Electronics 2CV500 - 4CH - Manual (Page 28)

28 CV500 - 4CH
MAIN MENU...continued
To Change the Buzzer Time:
1. Highlight BUZZER TIME SETUP.
2. Select to access the Buzzer Time Setup Menu.
3. Highlight the type of alarm you want to set.
4. Use the mouse wheel or directional keys to change the length of time the buzzer will sound when the alarm is detected.
5. Press Menu or select the to return to the Main Menu, or press the ENTER key.
6. Press Menu or select the to exit the Main Menu and save your settings. The DVR may take a few moments to load the settings.
RELAY TIME SETUP
The DVR has a connection for an alarm relay output. This allows you to connect a 2 wire Normally Open (NO), or Normally Closed (NC) connection to
an external alarm source like a siren, flashing lights, or an existing two wire security system.
Relay time setup allows you to adjust the length of time the DVR will send an electrical signal through the connected relay device. An external
power source is likely required. Please contact your alarm manufacturer for information and assistance with your alarm.
Please note that SVAT does not provide support for external alarm systems.
To Setup the Relay Time Setup:
1. Select RELAY TIME SETUP from the Alarm Setup Menu.
2. Select to access the Relay Time Setup Menu.
3. Highlight the type of alarm you want to set up.
4. Use the mouse wheel or directional keys to change the length of time. The 12V signal will be sent to your external alarm when an alarm is
detected.
5. Press Menu or select the to return to the Main Menu or press the Menu button.
6. Press Menu or select the to exit the Main Menu and save your settings. The DVR may take a few moments to load the settings.
HARD DISK MANAGEMENT SETUP
The DVR comes with a preinstalled hard drive. The HDD (Hard Disk
Drive) Management Menu will allow you to display the space left in
the hard drive, clear saved footage and set other HDD related options.
1. Access the Main Menu by pressing Menu or from the Pop Up
Menu Bar.
2. Select the Main Menu icon
.
3. In the Main Menu, select HDD Management .