Sierra Raven EDGE - Manual (Page 91)

Raven EDGE
87 20070914
*NETUID=uid
The login that is used to login to the cellular network, when
required.
• uid=user id (up to 64 bytes)
*STATICIP=d.d.d.d
Set the static IP required to be received from the network. If the
modem does not get this IP address from the network, it will
reset the internal hardware and try again. The default is 0.0.0.0,
which allows any IP address from the network.
• d.d.d.d=IP address
Example:
AT*STATICIP=192.168.1.23
Caution: STATICIP does not set the IP address of the modem, it
merely tells the modem which IP address to expect. If the expected IP
address is not granted while registering on the cellular network, the
modem will try to register on the network again until it receives that IP
address. If your account is set up for a dynamic IP address and you
set an address for *STATICIP, you may not be able to register on the
network at all since there is no guarantee you will receive the same
dynamic IP address again.
*STATUSCHK=n
Checks if an SMS message has been received by the modem.
• n=1‐255 : Seconds between checks.
• n=0 : Never check.
*MODEMHISPEED
Set the internal serial link speed to the internal (radio) module.
• n=0 : 115200 (default)
• n=1 : 230400
DNS
This group includes commands specific to the modem being
able to use domain names instead of IP addresses for other
configuration options.