Sierra Raven EDGE - Manual (Page 85)

Raven EDGE
81 20070914
Tip: Use *NETALLOWZEROIP if you need to allow the display of an
IP ending in a zero.
*NETOP?
The current cellular carrier from the modemʹs firmware
version, for example, your cellular provider.
*NETRSSI?
The current RSSI (Receive Signal Strength Indicator) of the
Raven as a negative dBm value.
Tip: The same information is displayed with the command S202?.
*NETSERV?
The type of service being used by the modem, for example
Tech.
*NETSTATE?
The current network state:
• Connecting To Network: The Raven is in the process of
trying to connect to the cellular network.
• Network Authentication Fail: Authentication to the
cellular network has failed. Verify settings to activate the
Raven.
• Data Connection Failed: The Raven failed to connect, and
it is now waiting a set time interval before it attempts to
reconnect. Verify settings to activate the Raven.
• Network Negotiation Fail: Network connection negoti‐
ation failed. This is usually temporary and often clears up
during a subsequent attempt.
• Network Ready: The Raven is connected to the 1x cellular
network and ready to send data.
• Network Dormant: The Ravenis connected to the 1x
cellular network, but the link is dormant. It will be woken
up when data is sent or received.
• No Service: There is no cellular network detected.
• Hardware Reset: The internal module is being reset. This
is a temporary state.
+ICCID
Subscriber Identity Module ID. .