SATO XL400/410 - Manual (Page 63)

Programming Manual 2. Command Codes
SATO RISC Printers 63
Mirror Image
(From Firmware Version1E2050, 1E3002 for 6xxVA)
Command Structure:
RMaaaa, bbbb
aaaa:
Horizontal position of the top left corner of the image
area to be mirrored 0008 ~ 9999 dot.
bbbb: Vertical position of the top left corner of the image area
to be mirrored 0008 ~ 9999 dot.
Example: RM0150, 0050
Function/Placement:
This command allows you to print a data as mirrored, not only whole
or part of data.
If you specify the image area with horizontal and vertical po-
sition, both specified before command are valid for start positi-
on.
A data with command parameter over the printable area is not
mirrored as treated as a command error. Also, a print job with
command without print date is treated as a command error.
command can be used without command parameters for hori-
zontal and vertical position. In this case, data placed before this com-
mand are mirrored.
This command can be used with <%> command, while do not use with
command regardless of its effect.
Note:
1. This command can not be used with commands requiring re.edit-
ing print image, like sequential numbering, RTC, Copy image or
so. Also, it can not be used with commands for data storage, like
graphic, format, etc.
2. This command should not be used with bar codes to avoid the
scanning problem caused by refractive index through the glass
or the window.
3. Do not specify this command multiple times in a job.