SATO XL400/410 - Manual (Page 118)

118 SATO RISC Printers
2. Command Codes Programming Manual
Note
1. Commas must be used to separate the parameters. If a parameter
is omitted between two commas, the default Non-Standard Pro-
tocol Command codes for that parameter will be used.
2. This command must be sent as an independent data stream
immediately following the A Start code and immediately
preceding the Z Stop code. No other commands can be
included in the data stream.
3. If more or less than nine commas are included in the command,
the entire command sequence will be ignored. The command
must contain exactly nine commas.
4. If two characters are specified for a parameter, it will be inter-
preted as a hex value. For example:
Command ParameterResulting Command Code
2B+
++
If a combination of characters are outside the hexadecimal range,
the entire command sequence will be ignored.
5. Downloading Auto Online and Zero Slash settings will overwrite
the values selected using the LCD panel. If these settings are
changed using the LCD panel, they will overwrite any previously
downloaded settings.