SATO XL400/410 - Manual (Page 202)

202 SATO RISC Printers
8. Custom Characters And Graphics Programming Manual
3. Transfer the image into two bit map representations and then into
hexadecimal or binary format.
ROW BIT MAP HEX
1 0000 0001 0000 0000 01 00
2 0000 0011 1000 0000 03 80
3 0000 0111 1100 0000 07 C0
4 0000 1111 1110 0000 0F E0
5 0001 1111 1111 0000 1F F0
6 0011 1111 1111 1000 3F F8
7 0111 1111 1111 1100 7F FC
8 1111 1111 1111 1110 FF FE
9 0000 0111 1100 0000 07 C0
10 0000 0111 1100 0000 07 C0
11 0000 0111 1100 0000 07 C0
12 0000 0111 1100 0000 07 C0
13 0000 0111 1100 0000 07 C0
14 0000 0111 1100 0000 07 C0
15 0000 0111 1100 0000 07 C0
16 0000 0111 1100 0000 07 C0
4. To store the custom designed character in memory using a hexadec-
imal data stream, the command would be:
A
T1H3F0100038007C00FE01FF03FF87FFCFFFE07C007C007C
007C007C007C007C007C0Z
Note: This should be a continuous data string without any CR or LF
characters.
5. To recall the custom character from memory, send the following code
to the printer. Note that you can print other data as well. Also note how
the character size was expanded using the L command.
A
L0505H0150V100K1H903F
L0505H0600V100K1H903F
L0303H0125V0250MTHIS SIDE UP !
Q1
Z